If you would like to try out PC+ to see if it's suitable for your use-case, send us a message, and we'll give you 25% off your first order of PC+.
Polycarbonate is an extremely strong, impact resistant thermoplastic that is widely used in industrial applications. This material does not shatter like plexiglass. It tends to bend and deform similar to hard rubber until it eventually breaks. PC absorbs a lot of moisture in the air. It is a hygroscopic material, and it is best to store in an airtight container when not in use. Even during use the material can become unprintable within a 24 hour print if in a humid environment. Therefore, keeping in an airtight container during printing as well is ideal. Dry filament will print more clear. Filament that has absorbed moisture will print white as well as pop and bubble during the print. We usually don't leave PC+ out for more than 3 days.
Our PC+ differs from pure PC as it contains additives to make it easier to print reliably.
- High strength and heat resistance
- Malleable while cold and can be bent without cracking
- Exceptionally durable
|Print temp (°C)||235 ~ 260|
|Bed temp (°C)||90 ~ 100|
|Speed (mm/s)||60 - 100|
|Net Weight (kg)||1|
|Gross Weight (kg)||1.5|
|Full Length (1.75 mm)||396 M|
Our print settings:
|Printer||UltiBots D300VS+ & UltiBots D300VS|
|Bed Temp||55°C |
|Layer Height||.2 mm (.4 mm hardened nozzle)|
|Print Speed||60 mm/s loops and infill and 30 mm/s perimeters|